Kinetic Kitchen and Bath is proud to be the first and only dealer/ installer of the Safeway step tub conversion in Western NY.

We can convert almost any existing tub into a walk in tub or shower, quickly, and at a fraction of the cost of installing a new walk in tub or shower

Installation of our products include cutting a section of the existing tub and custom fitting the resulting opening with a Safeway Step® or Safety Bath Door Insert. There are product options for most types of bathtubs, including - fiberglass, steel or even cast iron!

Benefits and features of the Safeway Step® and Safety Bath Door Insert include:

Eliminates the need to rip out existing tub. Installed in the existing tub.

• Options available with or without a door.
• Provides easier access into bath/shower area.
• Reduces the possibilities of falls.
• Typically Installed in less than one day.
• Cost to install products is fraction of cost compared to expensive bathroom remodeling job.
• Inexpensive and ideal solution for both personal residences, senior housing, hotels and other locations.

Pricing for the tub to shower - doorway kit is only $1,199, fully installed! the walk in tub version with a door, is priced at only $1,599, also fully installed

Please Contact Anne Daggett at (716) 297-7100 ex 106 or on her mobile phone at (716)909-7959 for more information

Read about us in "AFTER 50 MAGAZINE"

To read more of After 50 Magazine go to: http://www.after50news.com/options/rehab/rehaboptions

Watch us install the step insert into our showroom display.....

Hello I'm Chris Connelly, President and owner of Kinetic Kitchen and Bath. I am going to install the safeway step insert into one of the display tubs in our showroom

We start working just after 2:00

We chose to install the step in a fairly standard size fiberglass tub

first we mark the doorway with a template

Next is really the hardest part, we have to cut out the opening (VERY CAREFULLY) while we can install the product into virtually any tub, fiberglass tubs cut the easiest, then steel, and last is cast iron... we have to grind the opening into cast iron which takes longer and makes a bit more noise and mess, but we encapsulate the entire room in plastic so its spotless when we are finished.

finally the cutting is complete

Now I have to trim the step insert to meet the exact profile of your tub. in order to do this, I first make a template of the wall of your tub, then trace it onto the step insert, and finally (VERY CAREFULLY) cut the insert to meet the profile of the tub.

bottom reinforcement is applied

Finally the step in fastened with high strength adhesive.

The whole process usually takes less than 1/2 a day!!!